How do I tie a tie?

The most classic, reliable method is the Four-in-Hand knot. It is simple, slightly asymmetrical, and works well for almost any occasion.

Here is how to do it:

1. Start: Drape the tie around your neck. The wide end should be on your right and the narrow end on your left. Position the wide end about 12 inches lower than the narrow end.
2. Cross over: Bring the wide end over the narrow end to the left.
3. Under: Bring the wide end under the narrow end and back to the right.
4. Across: Bring the wide end over the front again to the left. You have now created the "loop" for the front of your knot.
5. Up: Pull the wide end up through the neck loop from underneath.
6. Down: Feed the wide end down through the loop you created in the front (the knot).
7. Tighten: Hold the narrow end and slide the knot up toward your collar. Adjust it so it’s snug and centered.

Pro-tips:

• The Length: When you are finished, the tip of the wide end should ideally hit right at the middle of your belt buckle. If it is too short or too long, adjust the starting position of the narrow end and try again.
• The Dimple: For a polished look, just before you pull the knot tight in the final step, use your index finger to press a small indent in the center of the fabric just below the knot. This creates a professional-looking "dimple."
• Practice: Don't get discouraged if it takes a few tries! Most people need to practice the motion a few times to get the tension and the length just right.